3/26/2021 0 Comments Cisco Aironet Access Point Setup
You can use a local connection to the Ethernet port much as you would use a serial port connection.The contents of this chapter are similar to the instructions in the quick start guide that shipped with the wireless device.You can configure all the settings described in this chapter using the CLI, but it might be simplest to browse to the wireless devices web-browser interface to complete the initial configuration and then use the CLI to enter additional settings for a more detailed configuration.The MAC address can be found on the label on the bottom of the access point (such as 00164625854c).
Cisco Aironet Access Point Setup Serial Port Connection![]() To reset all settings except the IP address to defaults, click the Reset to Defaults (Except IP) button. If you want to erase everything including the static IP address, in addition to the above commands, use the erase and erase boot static-ipaddr static-ipmask command. Wait until the access pointbridge Install Mode LED begins to blink green before continuing with CLI configuration changes. You can also see the following CLI message when the load process has finished. To obtain the access pointbridges new IP address, you can use the show interface bvi1 CLI command. Follow the steps in the appropriate section to connect to the devices console port. If you are not able to console into the device with the flow control value set to none, try changing the flow control value to XonXoff. You can find out the DHCP-assigned IP address using one of the following methods. Follow the steps in the Connecting to the 1100 Series Access Point Locally section or in the Connecting to the 1140,1200, 1230, 1240, and 1250 Series Access Points Locally section to connect to the console port. Your network administrator will query the DHCP server using the MAC address to identify the IP address. The access points MAC address is on label attached to the bottom of the access point. If it does not receive an address, it assigns itself the IP address 10.0.0.1 for five minutes. During this five-minute window, you can browse to the default IP address and configure a static address. If after five minutes the access point is not reconfigured, it discards the 10.0.0.1 address and reverts to requesting an address from the DHCP server. If it does not receive an address, it sends requests indefinitely. If you miss the five-minute window for browsing to the access point at 10.0.0.1, you can power-cycle the access point to repeat the process. Cisco Aironet Access Point Setup Install Mode InTo configure it as a bridge, you must manually place it in install mode in order to align the antennas and establish a link. To establish the link you must have two access pointbridges configured in the install mode. In the install mode, one access pointbridge must be configured as a root bridge and the other a non-root bridge. To facilitate the configuration, an automatic option is available when the access pointbridge is in the install mode. After the wireless link is established and the bridge antennas are aligned, you take both access pointbridges out of install mode and place them on your LAN as root and non-root bridges.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |